Owner Manual

Step 4: Install the power cord
Skip this step if the dishwasher will be direct wired.
1. Remove the junction box cover on the right front of the dishwasher.
2. Connect the incoming white (or ribbed) wire to the dishwasher’s white wire, the
black (or smooth) wire to the dishwasher’s black wire, and the ground wire to the
dishwasher’s green wire. Use cUL/UL listed wire nuts of the appropriate size.
3. Replace the junction box cover on the right front of the dishwasher. Be sure that
the wires are not pinched
Step 5: Install the 90° water supply elbow
1. Wrap the male thread of the 90° elbow with Teflon thread seal tape. Do not use
plumber's putty.
2. Install the 90° elbow onto the water valve. Do not overtighten the 90° elbow. The
water valve bracket could bend or the water valve fitting could break.
3. Position the end of the elbow to face the bottom right side of the dishwasher.
Use Philips screwdriver, power cord, wire nuts, adjustable wrench, 90° elbow, and
Teflon thread tape.
Page 13