Owner Manual

IINSTALLATION INSTRUCTIONS
Step 1: Check the door balance
1. Hold the top of the dishwasher firmly.
2. Open the door slowly, then release it. If
the door drops, increase the spring
tension. If the door closes, decrease the
spring tension.
3. Continue moving the spring pin until the
door is balanced. Adjust both springs to
the same tension.
Step 2: Adjust the leveling legs
1. Move the dishwasher close to the
installation location and lay it on its
back.
2. Measure the installation height
and the dishwasher height.
3. Extend the leveling legs out from
the dishwasher base 1/4 in. (6.35
mm) less than the installation height.
Step 3: Remove the toekick
Remove the two toekick screws with a Phillips screwdriver, then remove the toekick.
Use adjustable wrench and Philips screwdriver.
Page 12