INSPIRING THE WORLD’S KITCHEN DROP-IN GAS COOKTOP DIC SERIES INSTALL & USER GUIDE IMPORTANT SAFETY INSTRUCTIONS Carefully read the following Important information redarding installation safety and maintenance. Keep these instruction for future reference.
THANK YOU FOR YOUR PURCHASE TABLE OF CONTENTS Thank you for your purchase. We know that you have many brands and products to choose from and we are honored to know that you have decided to take one of our products into your home and hope that you enjoy it. SAFETY INSTRUCTIONS COSMO appliances are designed according to the strictest safety and performance INSTALLATION INSTRUCTIONS 5-12 standard for the North American market.
IMPORTANT SAFETY INSTRUCTIONS INSTALLATION INSTRUCTIONS IMPORTANT SAVE FOR LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. OBSERVE ALL GOVERNING CODES AND ORDINANCES. ! This appliance shall only be installed by an authorized person and shall be installed in accordance with the manufacturers installation instructions.
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS This appliance can be used with Natural Gas and LP Gas. It is shipped from the factory adjusted for use with Natural Gas. Propane conversion kits can be purchased separately. The maximum inlet gas supply pressure incoming to the gas appliance pressure regulator is 20’’ water column (5 kPa). The minimum gas supply pressure for checking the regulator setting shall be at least 1“ w.c.
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS 5. For NG models the gas supply is connected to the regulator loose. The inlet connection has a 1/2” B.S.P. male thread. IT IS ESSENTIAL THAT THE ELBOW ON THE APPLIANCE BE HELD FIRMLY WITH A SPANNER WHEN CONNECTING THE SUPPLY. DO NOT OVER TIGHTEN. The regulated pressure for NG is 4” W.C. (See Fig. 5). 6. For gas inlet position of appliance refer Fig 5, 6 and 7.
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS GAS CONVERSION Before carrying out any maintenance work, disconnect the appliance from the gas and electric supply. CHANGING THE BURNER NOZZLES Lift up the burners and unscrew the nozzles ( Fig. 8) using an adjustable wrench of 7 mm and change the nozzles with those designed for the new gas supply according to the information given in TABLE A shown below.
INSTALLATION INSTRUCTIONS OPERATING INSTRUCTIONS WARNING Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquid. REGULATION OF BURNER FLAME INTENSITY To regulate the minimum flame on the burners, carry out the following procedure indicated below: 1) Turn on the burner and put the knob onto position MINIMUM (small flame). 2) Remove the knob ( Fig. 9) of the tap which is set for standard pressure. The knob is found on the shaft of the valve itself.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS • Ensure good ventilation of the room. Keep adequate natural ventilation or install an extractor hood with a discharge tube. In case of doubt, ask a professional installer for advice. • Supply the appliance with the type of gas stamped on the relevant label situated in the immediate vicinity of the gas connection tube. • To facilitate ignition, light the burners before placing pans on the grid. Check that the flame is regular.
CARE INSTRUCTIONS CARE INSTRUCTIONS CLEANING THE COOKTOP Periodically clean the burner heads, the cast iron pan supports and the burner caps using warm water. Remove burned food and fat residues with a rubber spatula . If food residue prevent the smooth operation of the control knobs, call the customer service hotline to schedule service by a factory-trained professional. CLEANING THE STAINLESS STEEL For best results use a stainless steel cleaner product with a soft sponge or wipe.
REFERENCE FIGURES REFERENCE FIGURES 30" MODEL : W = 30" , D= 21" 36" MODEL : W= 36", D = 21" Fig. 1 Fig. 3 Fig. 2 Fig. 4 Fig. 5 A = 1.29" B = 1.73" Fig. 6 Table n. 1 Fig. 7 18 19 A = 3.7" B = 1.72" E = 6.25" F = 1.76" Fig. 8 Fig.
REFERENCE FIGURES Fig. 10 Fig. 12 Fig. 14 Fig. 11 Fig. 13 Fig.
IMPORTANT Do Not Return This Product To The Store If you have a problem with this product, please contact Cosmo Customer Support at +1(888)784-3108 DATED PROOF OF PURCHASE, MODEL #, AND SERIAL # REQUIRED FOR WARRANTY SERVICE IMPORTANT WARRANTY AND SERVICE Ne pas Réexpédier ce Produit au Magasin Pour tout problème concernant ce produit, veuillez contacter le service des consommateurs Cosmo Customer Support au +1(888) 784-3108 UNE PREUVE D’ACHAT DATEE EST REQUISE POUR BENEFICIER DE LA GARANTIE.
Cosmo is constantly making efforts to improve the quality and performance of our products, so we may make changes to our appliances without updating this manual. Electronic version of this manual is available at: www.cosmoappliances.
