User's Manual

Specification #8810502 Original 5/14/98
ABS<Comtrak

 1700-1702
Installation & Start-up Procedure
7 Revision, 1/5/99
FCC Requirements
1. The Federal Communications Commission (FCC) has established Rules
Which permit this device to be directly connected to the telephone network.
Standardized lacks are used for these connections. This equipment should not
be used on party lines or coin phones.
2. If this device is malfunctioning. it may also be causing harm to the telephone
network; this device should be disconnected until the source of the problem can
be determined and until repair has been made. If this is not done, the telephone
company may temporarily disconnect service.
3. The telephone company may make changes in its technical operations and
procedures: if such changes affect the compatibility or use of this device, the
telephone company is required to give adequate notice of the changes. You will
be advised of your right to file a complaint with the FCC.
4. If the telephone company requests information on what equipment is
connected to their lines, inform them of:
a. The telephone number to which this unit is connected. End user phone
number
b. The ringer equivalence number. 0.7B
c. The USOC jack required. RJ 11
d. The FCC Registration Number.
OAM170102
items M and (d) are indicated on the label. The Ringer Equivalence Number
(REN) is used to determine how many devices can be connected to your
telephone line. In most areas, the sum of the REN's of all devices on any one
line should not exceed five (5.0). If too many devices are attached, they may not
ring properly.
Service Requirements
In the event of equipment malfunction, all repairs should be performed by our
Company or an authorized agent. It is the responsibility of users requiring service
to report the need for service to our Company or to one of our authorized agents,
Service can be obtained at
Advanced Business Sciences, Inc.
3345 North 107
th
street
Omaha, NE
68134-3664
pH: 402-498-2734
Fax: [phone]