Instruction Manual

DVR User Manual

4.8 P.T.Z Configuration

P.T.Z configuration includes two submenus: serial port and advanced settings.

Serial port settings are as follows:

Step 1: Enter into MenuSetup  P.T.Z Serial port tab. Refer to Fig 4-37:

Step 2: Select “enable” and setup the value of address, baud rate and protocol according to the settings of the speed dome.

Step 3: Configure all channels with the same parameters by selecting the “All” box and then doing the relevant setup.

Fig 4-37 P.T.Z Configuration-Serial Port

Definitions and descriptions of network stream:

Parameter

Meaning

Address

The address of the PTZ device

Baud rate

Baud rate of the PTZ device. Range form: 110, 300, 600, 1200, 2400,

4800, 9600, 19200, 34800, 57600, 115200, 230400, 460800, 921600.

Protocol

Communication protocol of the PTZ device. Range from: NULL, PELCOP,

PELCOD, LILIN, MINKING, NEON, STAR, VIDO, DSCP, VISCA,

SAMSUNG, RM110, HY, N-control.

Simulative

Cruise

If enabled, no matter whether the PTZ device supports cruise or not, the

presets will cruise.