Instruction Manual

DVR User Manual
33
4.6.3 Email
Step 1: Enter into MenuSetupNetworkEmail tab. Refer to Fig 4-31:
SMTP Server/Port: The name and port number of SMTP server. Check the
SSL checkbox if the server requires a secure connection (SSL); user can setup
mail servers (such as Gmail) as required.
Send address/password: Sender‟s email address/password
Receive address: Receiver‟s email address. Here user can add at least three
mail addresses. Click TEST button to test the validity of the mailbox.
Attaching image: After selecting it, the system will attach images when
sending the emails.
Fig 4-31 Network Configuration-Email
4.6.4 Server
This function is mainly used for connecting ECMS. The setting steps are
as follows:
Step 1: In the server tab, select “enable” as shown in the Fig 4-32.
Step 2: Check the IP address and port of the transfer media server in the
ECMS. The default server port for auto report is 2009. If it is modified,
please enter into the transfer media interface to check.
Step 3: Enable the auto report in the ECMS when adding a new device.
Then input the remaining information of the device in the ECMS. After that,
the system will auto allot a Device ID. Please check it in the ECMS. Fig 4-32 Network Configuration-Server
Step 4: Input the above-mentioned server IP, server port and device ID in the server interface .Then click “Apply” button to save
settings. Now, the ECMS system will automatically connect this device.