User guide

i-on160 3. Setting and Unsetting
Page 23
being monitored. If there is any activity on any detector
then the system will start an alarm.
“Part Set” means that the system is monitoring some
detectors but not others. The installer selects those
detectors that should be monitored during a Part Set.
“Partition” is a segment of the whole system that may not
be accessible to some users. Some users can only set a
single Partition. Other users may be able to set two, three
or more Partitions. See below for instructions on how to
set and unset individual Partitions.
Setting/Unsetting Partitions From a
Keypad:
If the installer has split your system into “partitions” you may be
allocated to more than one of them. In that case you can set (or
unset) each partition independently of all the others.
Do this: The display shows:
1. Make sure the system is idle.
If you want to set a partition,
secure all the windows and
doors in that partition.
(The top line may show the
installer’s name.)
i-on160EX
12:20 02/11/2010
2. Either key in your access code
As you key in your code the
display shows a “*” for each digit.
Enter Access Code:
(** )
OR present your tag.
The bottom line of the display
shows the first item in the
setting options menu.
Setting Options ↕
Full Set All
Note: If you walk into a partition
and start the entry timer (you
can hear the entry tone) then
as soon as you enter a valid