User guide

i-on160
Page 12
2. Alarms
The table below shows the different kinds of alarms possible.
Type of
Alarm
Signal
(see note)
Started by:
Intruder Loud warbling
tone from
siren.
Normal alarm or entry route zone
activated when system is set.
24 hour zone activated at any time.
Fire Pulsing tone
from siren.
Fire zone activated at any time.
Panic Loud warbling
tone from
siren
PA zone or Panic Alarm transmitter
activated at any time.
Pressed on keypad.
(The installer must enable this
feature on your system.)
Technical Quiet beeping
once per
second from
keypads.
Technical alarm zone activated at
any time.
Fault Quiet beeping
once per
second from
keypads.
A system fault detected by the
control unit, for example, mains
failure, or communications line fault.
See page 16.
Silencing an Alarm
In an alarm the sirens run for a limited time set by the installer (a
maximum 15 minutes for intruder and panic alarms).
If you return to the system while the sirens are running you can
silence the siren as follows: