Installation Manual

Page 22
If you will install the unit on the ground or
on a concrete mounting platform , do the
following:
1. Mark the positions for four expansion bolts
based on dimensions in the Unit Mounting
Dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Clean concrete dust away from holes.
4. Place a nut on the end of each expansion bolt.
5. Hammer expansion bolts into the pre-drilled
holes.
6. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
7. Put washer on each expansion bolt, then
replace the nuts.
8. Using a wrench, tighten each nut until snug.
WARNING
Step 3: Anchor outdoor unit
The outdoor unit can be anchored
to the ground or to a wall-mounted
bracket.
UNIT MOUNTING DIMENSIONS
The following is a list of dierent
outdoor unit sizes and the distance
between their mounting feet.
Prepare the installation base of the
unit according to the dimensions
below.
A
W
B
D
Air inlet
Air outlet
Air inlet
A
W
B
D
Air inlet
Air outlet
Air inlet
Fig. 4.5
Outdoor Unit
Installation
WHEN DRILLING INTO CONCRETE, EYE
PROTECTION IS RECOMMENDED AT ALL
TIMES.
Outdoor Unit Dimensions (in/mm)
W x H x D
Mounting Dimensions
Distance A (in/mm) Distance B (in/mm)
26.8”x17”x11.2” (681x434x285) 18.10” (460) 11.49” (292)
27.5”x21.6”x10.62” (700x550x270) 17.7” (450) 10.24” (260)
30.7”x21.25”x9.85” (780x540x250) 21.6” (549) 10.85” (276)
33.25”x27.5”x12.6” (845x700x320) 22” (560) 13.2” (335)
31.9”x22”x12.2” (810x558x310) 21.6” (549) 12.8” (325)
35.4”x33.85”x12.4” (900x860x315) 23.2” (590)
13.1” (333)
37.2”x31.9”x15.55” (945x810x395) 25.2” (640)
15.95” (405)
37.21”x31.9”x16.53” (946x810x420)
26.5” (673) 15.87” (403)
37.21”x31.9”x16.14” (946x810x410)
26.5” (673) 15.87” (403)
33.25”x27.63”x14.29” (845x702x363)
21.26” (540)
13.8” (350)
27.5”x21.6”x10.82” (700x550x275) 17.7” (450) 10.24” (260)
30.3”x21.85”x11.81” (770x555x300) 19.2” (487) 11.73” (298)
31.5”x21.8”x13.1” (800x554x333) 20.24” (514) 13.39” (340)