Owners Manual

ManualsBrandsContinental Refrigerator ManualsCommercial Equipment29" Pass-Thru Refrigerator with 22 cu. ft. Capacity, Solid Half Doors, LED Lighting, Electronic Controller and Self Contained Performance-Rated Refrigeration System in Stainless Steel

REACH-INS & ROLL-INS

OPERATIONS MANUAL

PAN SLIDE INSTALLATION

Pan slides should be installed in pairs, to ensure each set is

level at the same height. Before installing the slides, determine

the spacing desired between each pan that will be placed in the

cabinet. Align one of the pan slides against the vertical support

(see Figure 11A). Simultaneously insert the (2) studs on the

slide into the upper end of the slot on the vertical supports at the

desired height and the pan slide will simply drop down and lock

into place. Install another slide into opposite vertical supports,

using the same method. Check that the pair of slides are level

and at the proper height. Repeat this procedure for the remain-

ing sets of pan slides.

2. All refrigerant should be removed from the system by a

qualified technician and disposed of properly, or reclaimed.

(Intentional venting of many refrigerants into the air is harm-

ful and prohibited; violators are subject to fines). All refriger-

ant oil should be drained from the compressor and discarded

appropriately.

3. Properly dispose of the cabinet and refrigeration system

components. The majority of the metal in your unit (stainless

steel or aluminum cabinet shell and doors, steel shelving and

compressor, copper refrigerant lines, etc.) can be recycled.

Many recycling facilities will dispose of the unit free of

charge, or pay you for scrap value of the material content.

OPTIONAL ACCESSORIES

PAN SLIDE ASSEMBLIES

Pan slide assemblies are available in a variety of configurations

(see Figure 11). The unique design of the vertical supports

allow the pan slides to be mounted on 1” centers and be read-

ily removed for cleaning, without the use of tools or additional

hardware. If your new unit was ordered from the factory with

pan slides, the vertical supports will be pre-installed directly on

the outer walls of the cabinet. On 2- and 3-section cabinets, the

vertical pan supports in the middle of the cabinet are mounted to

center supports as shown (see Figure 11A). The pan slides are

wrapped up in the accessory package, inside the cabinet.

FIGURE 11: Pan Slide Assembly Configurations

LH SLIDE

SUPPORT

CENTER

VERTICAL

SUPPORT

RH SLIDE

SUPPORT

PAN

SLIDES

PAN SLIDE

INSTALLATION

PAN SLIDES MOUNTED IN 2 SECTION INTERIOR

FIGURE 11A: Pan Slide Assembly Components