Datasheet

Product Specification No. S513-1035 Page 1/3

1. Applied Scope

This

S513-1035 / 10000 x 35 x 2.0mm

product specification applies to 10000 × 35 × 2.0mm+3M#55230 adhesive product.

Part Name and Size

Material

Magnet : EP-7S ； adhesive: 3M#55230 double-sided adhesive

Material Characteristics

4.1 Material Magnetic Characteristics

Item SI Units CGS Units

Residual flux density (Br)

180±15 mT 1800±150 Gs

Coercive force (Hcb)

103.4±16 KA/m 1300±200 Oe

Intrinsic (Hcj)

15９±28KA/m

　　　2000±350 Oe

Maximum (BH)max

5.6±0.8 KJ/m3 0.7±0.1 MGOe

4.2 Material Chemical Characteristics

Item TEST CONDITIONS Determined

Hydraulic At room temperature, 96 hours immersion excellent

Alcohol At room temperature, 96 hours immersion good

A ketone,

ethyl ether

At room temperature, 96 hours immersion bad

Alkalescent At room temperature, 96 hours immersion good

Acids At room temperature, 96 hours immersion bad

4.3 Material Physical Characteristics

Density 3.70±0.1(g/cm

)

Hardness shore(D)=40～65

Bending Winding in cylindrical fixture does not produce Φ1９mm fracture phenomena

PAGE 1
Product Specification S513-1035 No. Page 1. Applied Scope This product specification applies to 10000 × 35 × 2.0mm+3M#55230 adhesive product. 2. Part Name and Size S513-1035 / 10000 x 35 x 2.0mm 3. Material Magnet : EP-7S ； adhesive: 3M#55230 double-sided adhesive 4. Material Characteristics 4.1 Material Magnetic Characteristics Item SI Units Residual flux density (Br) 180±15 mT Units 1800±150 Gs Coercive force (Hcb) 103.
PAGE 2
Product Specification S513-1035 No. Page 4.4 Reliability Test TEST CONDITIONS Item Weatherability Determined 63 ℃, 60 Fenzhong sunlight (12 minutes rain), good carbon arc lamp irradiation Moisture 40℃，90 ％RH，168 hour excellent Salt Spray Test ５％ Saline excellent Waterproof 65 ℃ of water, 25 ℃ saline, 30 minutes, 2 cycles excellent Ozone resistance 80ppm,25℃,72 hour Acceptable Resistance ,96 hour 5. Magnetization Specification P = 4.
PAGE 3
Product Specification Determine No. S513-1035 Page standard : C=0 7.3 Curve 1）Winding in cylindrical fixture does not produce Φ19mm fracture phenomena. 2）Determine standard : C=0 7.4 Appearance Test methods: visual, AQL=1.5 MIL-STD-105E-Ⅱ 8. Inspection Record " Inspection reports," With the goods counterparts. 9. Keeping Method To prevent rain and sunlight 10. Other 10.1 Move to take light-light. 10.2 Specification changes to be mutual consultation, agreed.