User manual

16
1.10 Experimenting Cable
Use the red and black experimenting cables at the ends of which alligator terminals
are connected to quickly and simply electrically connect parts to the circuit and to
each other – without soldering gun and screwdriver. It is sensible to use the red
connection cables for the plus pole and the black ones for the minus pole.
Fig. 012: Experimenting cable with alligator clamps
1.11 Jumper Wire
Wire bridges can be made of the enclosed jumper wire. For this, estimate or
measure the approximate length of the wire jumper (plus the length for the wire
ends that are to be pushed into the plug-in contacts). The ends must be stripped
on approx. 8 mm then. Connection wires that were cut off with a wire cutter can be
plugged more easily. The wire jumpers produced once can be reused as often as
desired.