Manual

20

Firmware updates for the BRIC-Link II should be handled using Comrex , a Windows- and MAC
OS-executable program that can be downloaded from the Comrex website.  can also be used for
license installaon and IP conguraon.
Please note: In order to congure a BRIC-Link II unit for the rst me (without knowing the unit’s IP address),
 must be run on a computer located on the same network (e.g. physical LAN connecon) as the
unit itself. If this is not possible, an Ethernet crossover connecon between the BRIC-Link II and a computer should
be used for conguraon.


As shown in 6, running the  and clicking the “” buon will produce a list of all Comrex
devices found on the LAN. If the default password has changed,  will prompt for the password to
BRIC-Link II aer the scan.
 shows the four tabs that appear on the right-hand pane aer has logged in. The fourth
tab is labelled . This will open a simplied setup interface on the BRIC-Link II called . The
 interface allows for conguraon of several opons including the Ethernet port. Log in to  with a
user name (any) and password (default = ) to enter the .
Once logged into , choose the  opon and then choose . Choose
the Ethernet port that appears in the list, which will look like .