Quick Start Guide

QSG_RLGE2FE16R_REV– 3 Aug 2016 PAGE 12
QUICK START GUIDE RLGE2FE16R
TECH SUPPORT: 1.888.678.9427
Modes of Operation
ACE vs GCE
GCE interface used for
» IP Management to switch (SSH, Terminal, SNMP, FTP)
» Routing of access traffic using static entries or OSPF
» Mainly used for Switching (Vlans, Interface Troubleshoot, System information, etc.)
ACE interface used for
» Layer 3 configurations (Firewalls, Cellular, Routing, IPSEC, DMVPN,etc.)
» Access Control Lists
» Authentication-Proxy
» Event Logger
Command Mode Access Method Prompt Exit Method Usage
Root Following user log in RLGE2FE16R# User needs to log
out using command
logout or exit
Issue Show
commands
Global Configuration
Environment (GCE)
Command Configure Terminal RLGE2FE16R(config)# Return to root mode
using command exit
or end
Issue configurations
Global Hierarchy
Configuration
From Global Configuration
mode you can access sub
tree feature. Ex. Interface
configuration sub tree
RLGE2FE16R(config-if)# Return to global
config using
command exit
Deep configurations
of device ranging
from interface to
routing, etc.
Application
Configuration
Environment (ACE)
Use the “application connect”
from the root mode to enter
the application configuration
area
[/] Exit to root mode
using exit and
pressing enter to see
prompt
Global Configuration
of the ACE
Application Hierarchy
Configuration
From application root you can
access sub tree feature. Ex.
Router interface
[router/interface] To go back to root of
application you must
type two dots (..) and
press enter
Deep configurations
of device ACE
ranging from cellular
to VPN, etc.