Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 54
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
VLAN Hybrid mode
To set Port 1 VLAN Hybrid mode = untagged 10
Tagged 10,20
Configure the VLAN for the Switch as shown
VLAN QinQ mode
Below is an example of the VLAN QinQ Mode, which is typically used in an environment with
unknown VLAN.
VLAN “X” = Unknown VLAN
P2 P2P1P1 P2 P1
CWGE26FX2TX24MSPOE
Switch A
CWGE26FX2TX24MSPOE
Switch B
CWGE26FX2TX24MSPOE
Switch C
VLAN Trunk
200
VLAN “X” VLAN “X”
Tagged 200
Tagged
200
Setting VLAN
QinQ 200
VLAN Trunk
200
tagged X
packet