Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 130
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
IGMP
IGMP>
Configuration [<port_list>]
Mode [enable|disable]
State [<vid>] [enable|disable]
Querier [<vid>] [enable|disable]
Fastleave [<port_list>] [enable|disable]
Router [<port_list>] [enable|disable]
Flooding [enable|disable]
Groups [<vid>]
Status [<vid>]
ACL
ACL>
Configuration [<port_list>]
Action [<port_list>] [permit|deny] [<rate_limiter>] [<port_copy>][<logging>]
[<shutdown>]
Policy [<port_list>] [<policy>]
Rate [<rate_limiter_list>] [<packet_rate>]
Add [<ace_id>] [<ace_id_next>] [switch | (port <port>) | (policy <policy>)]
[<vid>] [<tag_prio>] [<dmac_type>][(etype [<etype>] [<smac>] [<dmac>]) |(arp
[<sip>] [<dip>] [<smac>] [<arp_opcode>] [<arp_flags>]) |(ip [<sip>] [<dip>]
[<protocol>] [<ip_flags>]) |(icmp [<sip>] [<dip>] [<icmp_type>] [<icmp_code>]
[<ip_flags>]) |(udp [<sip>] [<dip>] [<sport>] [<dport>] [<ip_flags>]) |(tcp [<sip>]
[<dip>] [<sport>] [<dport>] [<ip_flags>] [<tcp_flags>])][permit|deny] [<rate_
limiter>] [<port_copy>] [<logging>] [<shutdown>]
Delete <ace_id>
Lookup [<ace_id>]
Clear
Mirror
Mirror>
Configuration [<port_list>]
Port [<port>|disable]
Mode [<port_list>] [enable|disable|rx|tx]
Config
Config>
Save <ip_server> <file_name>
Load <ip_server> <file_name> [check]