Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 100
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
Event Selection
SYSLOG and SMTP are the two warning methods that supported by the system. Check the
corresponding box to enable system event warning method you wish to choose. Please note that
the checkbox cannot be checked when SYSLOG or SMTP is disabled.
System Warning – Event Selection interface
The following table describes the labels in this screen.
Label Description
System Cold Start Alert when system restart
Power Status Alert when a power up or down
SNMP Authentication Failure Alert when SNMP authentication failure.
Redundant Ring Topology Change Alert when C-Ring topology changes.
Port Event
SYSLOG = event
› Disable
› Link Up
› Link Down
› Link Up & Link Down
Save Click to save the configurations.
Reset Click to reset the configurations.