Installation and Operation Manual

INSTALLATION AND OPERATION MANUAL

NETWAvE

INS_NetWave_REV– 06/10/13 PAGE 8

IMPORTANT: Only plug PoE power to Port 1.

Connectinga PoEpowersource to the PSEPort(#2) will

cause a major device malfunction and void the warranty.

Connect one end of an RJ‐45 Ethernet cable to the LAN OUT port of the Power Injection

Module (PIM) and the other end to LAN of the access point – as sown below.

Note: Maximum length of the RJ-45 CAT5 cable is 90 meters.

Connect the RJ‐45 Ethernet cable attached to the PIM to a network device, such as a switch or

to the configuration PC. Then plug the power adaptor to an AC power outlet and power plug

into the socket of the PIM – as shown in the diagram below.

Note: DC Passive PoE input for the NetWave Radios is 24 - 48VDC.

Connect one end of an RJ‐45 Ethernet cable to the OUT

port of the Power Injection Module (PIM) and the other end

to LAN of the access point.

Maximum length of the RJ‐45 CAT5 cable is 100 meters.*

Connect the RJ‐45 Ethernet cable attached to the PIM to a

network device, such as to a switch or to the PC you will use

to configure the access point.

Connect the power adaptor to the main electrical supply

and the power plug into the socket of the PIM.

PoE power input: Passive PoE (range 24 ‐ 48 VDC).

The unit can also be powered by a suitable IEEE 802.3af/at

PSE device such as a PoE switch or injector. Exception: the

NWK11/M Radios only accepts Passive PoE Power.

A Drip Loop is recommended as additional precaution

against moisture entering the Access Point housing.

*Up to200mW radio.Forhigher power radioupgradetohigher rating

power adapter.

Network

Edge Device

Ethernet

Network