User Manual

Removing access panels
IP-RN 8000 Installation & Commissioning Guide 91
Removing access panels
This procedure explains how to remove the two required access panels in order to install the Rox System
Cabinet seal and connect all antennas.
Be sure you have read and understood Understanding the antenna installation process
on page 86 before
continuing.
Requirements
• 5/32 tamper-resistant screw driver
• Thread tapping kit with 1/4-20 thread bit at 3/4 inch depth
Procedure
1. Ensure that power is not being delivered to the IP-RN 8000.
a. Ensure the Main Power switch on the Power Distribution Unit is flipped to the right.
See Understanding the Power Distribution Unit
on page 27.
b. Ensure the external circuit breaker that controls power flow to the IP-RN 8000 is opened,
eliminating power on the IP-RN 8000 circuit.
2. Locate the antenna access panel on the cabinet where you will install the Rox System.
There are four antenna access panels. The Rox System can be installed into any one of the cabinet
openings created when the access panels are removed.
The standard configuration requires installing the Rox System into the access panel on the top of the
back of the cabinet.
NOTE
Installing the Rox System cabinet seal into any of the three
non-standard access panels requires a different internal
configuration of the cabinet, and it must have been specially
ordered.