Warranty

ManualsBrandsCODEL DOORS ManualsBifold Doors36 in. x 80 in. Solid Wood Primed White Unfinished MDF 5-Panel Shaker Bi-Fold Door with Hardware

Table Of Contents

INTERIOR DOORS

Warranty

Trimlite guarantees all doors for a period of one

year from date of shipment from our plant

against defects which renders them

unserviceable for the use for which they are

intended by the manufacturer provided the

following conditions are met:

1. Manufacturing defects must be reported

promptly before tting, nishing, or hanging.

2. Provided that doors are operative, action on

any claims after installation may be deferr

ed at

the option of Trimlite for a period of six months

from date of complaint. During this time

period, doors must remain hung in the original

installation to permit conditioning to humidity

and temperature.

3. Trimlite agrees, at our option, to repair or

replace any doors that are defective within the

meaning of this guarantee. Claims for

rehanging, renishing, or other expenses for

work not originally performed by the

nufacturer will not be allowed.

4. Due to extreme weather conditions, exposures,

and architectural designs, Trimlite will not

guarantee any double door units, or outswing

units for air or water inltration where there is

not sucient overhang to protect the door.

5. The entire door, including edges, top, bottom,

and sides must receive at least two coasts of an

oil base paint, varnish, or sealer at the time of

nstallation. (See section: Finishing Instructions)

Allowable Tolerances

1. Thickness, width, and height tolerances from

nominal sizes shall not exceed 1/16” plus or

minus.

2. A squareness tolerance of not more than 1/8”

between two diagonal measurements taken

across the face of the door shall be allowed.

3. For doors 3’ x 7’ or smaller, deformaon (bow,

cup, twist, warp) shall not be considered a

defect unless it exceeds 1/4” i

n the plane of the

door itself

(door larger than 7’ warp not to exceed 3/8”)

When measure as speciﬁed in Clause 3.1.2.2

C.S.A. Standard -132.2- 1972.

Exclusion

The following are not defects in workmanship

of material and are not covered by this written

warranty:

1. Damage caused by attempts other than

Trimlite’s to repair the door and/or unit.

2. Failure to properly seal the door.

3. Defects caused by improper installation such

that the door doe

s not swing freely.

4. Damage cause by improper handling or on-site

storage.

Summary of content (2 pages)

PAGE 1
INTERIOR DOORS Warranty Trimlite guarantees all doors for a period of one year from date of shipment from our plant against defects which renders them unserviceable for the use for which they are intended by the manufacturer provided the following conditions are met: 1. Manufacturing defects must be reported promptly before fitting, finishing, or hanging. 2.
PAGE 2
INTERIOR DOORS Warranty 5. This warranty shall be void and Trimlite shall have no liability hereunder if the purchaser installs, treats, or retains, for more than thirty days, a door and/or unit containing an obvious defect, without giving the notice is required herein, or if the purchaser fails to give the required notice within reasonable time after discovery of defect. Door Policy 1. RECEIVING: Upon receiving, order must be checked for accuracy or damaged.