Compass Q Manufacturer ATONAL Overspends fondants LIMITED LIFETIME WARRANTY Compass Manufacturing International warrants to the original consumer purchaser that the faucet be free from defects In material and workmanship for 2s long as the original consumer purchaser owns the home in which the faucet was first installed.
+ Helpful Tools Tools: Gather the necessary tools as shown below to complete the installation of this faucet. Some may not be needed depending on the model of faucet you are installing. Plumber's Putty Flashlight Basin Wrench Safety Glasses and/or Silicone = Screwdriver Pliers Channel Locks Adjustable Ranch Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp cloth.
The supply valves and supply lines are not included. Connect to water supply lines with either: (A) 3/8” O.D. Copper tubing (ball nose risers with the coupling nuts or; (B) 3/8” Copper tubing (no ball) with supplied tube head interior connector or; (C) IPS faucet connectors (12") Let both hot and cold water run for one minute. This will help clean any debris that might clog 7 iN the system. Test system for leaks.
. Verify the O-ring (#21) is in place on the body {#186} and insert through the center hole. From underneath, assemble the clamp (#27) and screw on the lock nut Tighten the lock nut (#28) using a basin wrench. Note: Optional Add silicone sealant under body (#16) to prevent leaks. . Insert the brass valve body (#8) through the far left hole (hot water side).
