Compass @ Manufacturer ATONAL Overspends fondants LIMITED LIFETIME WARRANTY Compass Manufacturing International warrants to the original consumer purchaser that the faucet be free from defects In material and workmanship for 2s long as the original consumer purchaser owns the home in which the faucet was first installed.
If you're followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Photosynthesis Problem Cause Action Tools: Remove Handles (#4) and uninstall the Cartridge (#24 Hof Gather the necessary tools as shown below to complete the The watermill not turn | Cartridges (#24 Gator #37 16437 Cold) or Replace Cold) sack to ses If the . Re-i installation of this faucet. Some may not be needed depending off completely.
Shut off water supply and drain lines. Clean the surface area thoroughly. Make sure mounting area is clean and dry. 2. Position the shank@on counter top. From underneath the counter top, assemble washer, clamp @, screw@, and tighten with the screwdriver (But do not over tighten). Then connect the spout brass tee@to the shank 30. 3. Position the brass valve body @5 to the left of the shank on the counter top.
C A.% B Warning: The supply valves and supply lines are not included. Connect to water supply lines with either: (A} 3/8" 0.D. Copper tubing (ball nose risers with the coupling nuts or; (B} 3/8" Copper tubing (no ball) with supplied tube head interior connector or; (CLIPS faucet connectors (12") 1. Attach the spout to the spout valve ina counter-clockwise direction, install the set screw@ using the Allen key (3. Important: Tighten connection with two wrenches to prevent damage to tube body.