Installation Sheet

2
STEP
1
STEP
WALL
DRAIN
8"
FLOOR DRAIN
Connect a 2" drain pipe (not supplied) from scrap
accumulator to floor or wall drain.
Connect dishmachine to hot water source 120°F -
140°F. Connect cold water inlet (min 41°F and max
65°F). (Review other side for details).
Remove the plug from the mixing chamber and install
the rinse injection fitting (rinse injection fitting
provided by your dispenser supplier; CMA does not
supply).
Remove the plastic plug to install the detergent
fitting (provided by your dispenser supplier;
CMA does not supply).
3 Phase: Connect power supply wires, L1, L2 and L3
to the appropriate terminals marked L1, L2 and L3 on
the power block. Important: If one of the three wires
has higher voltage it must be inserted as L-2.
3
STEP
L2
L3
L1
208/240
3 PHASE OR SINGLE
PHASE
L1 AND L3
FOR SINGLE PHASE
01-2021
CMA-180-VL
REAR VIEW
4
STEP
PLASTIC
PLUG
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
DRAIN
CONNECTION
1
DETERGENT
FITTING INLET
4
HOT WATER
INLET
2
MIXING
CHAMBER
5
POWER
BLOCK
3
Push "RINSE TOGGLE SWITCH”, located on the back
of the control box, to fill the booster tank.
6
STEP
CMA-180-VL 3 Doors/Tall
Quick Setup Instructions
RINSE TOGGLE
SWITCH
LOCATED ON
BACK SIDE OF
CONTROL PANEL
6
5
STEP
HOT
WATER INLET
COLD
WATER INLET
COLD WATER INLET
LOCATED ON FRONT
OF MACHINE
2
PN: 10130.17