PRODUCT GUIDE & ASSEMBLY INSTRUCTIONS Console Table
Should you prefer to speak with a customer service representative, you may call toll free: 1-855-372-2315 2
Guidelines FAILURE TO FOLLOW THESE WARNINGS WHEN IN USE COULD RESULT IN INJURY • Do not stand on the item or use as a step ladder • Do not use this item unless all bolts and screws are firmly secured and fastened. • Check all bolts and screws every 90 days. As necessary tighten if any are loose. • Lift up then move. Pushing over or dragging this product can result in an injury or cause damage to the floor and piece.
WARNING: DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF INJURY. Pre-Assembly Preparation: Please read through this instruction booklet before beginning assembly of this item. Two adults are recommended for assembly. • Clear out the space for assembly and lay out all parts on Parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
Parts List Top (1) Legs (2) Legs (2) Shelf (1) Long Bolts (8) Short Bolts (4) Spring Washer (8) Flat Washer (8) Allen key 5mm (1) Allen key 4mm (1) 5
Step 1 1. Ensure all parts have been removed from the carton and place on a protected surface or carpet. 2. Check all parts and hardware are the same as the “Parts List”. 3. Attach Leg (B) x2 & Leg (C) x1 to Top (A), Leg position as below image, fasten with long Bolt (E), Spring Washer (G) and flat washer(H) then tighten with Allen Key (I).
Step 2 1.Insert Shelf (D) to Leg(B)x2 & Leg(C)x1 then attach Leg(C)x1 onto shelf (D). 2.Fasten Leg (C) with Top(A) by long Bolt (E), Spring Washer (G) and flat washer (H) then tighten with Allen Key (I). 3.Fasten Leg (C) with Shelf (D) by short Bolt (F), then tighten with Allen Key (J). Note: Please do not fully tighten all Bolts until the table is fully assembled.
Step 3 1. Place the console onto a flat level surface, once the table is level, Tighten all Bolts by Allen Key (I) & (J). Periodically (every 90 days) make sure that the screws are still fully tightened. ATTENTION: Be certain that all screws are fully tightened before using table.
Step 4 WE STRONGLEY RECOMEND THIS UNIT IS ATTACHED TO THE WALL TO PREVENT TOPPLE. KEEP YOUR PRODUCT SAFE FROM INJURY. Wall straps are already pre-assembled on your Furniture. Assembly Steps to attach your furniture to a wall 1. Use a pencil to mark the fixing positions on the wall. 2. Drill holes and insert appropriate wall plugs into wall (not provided). 3. Place the product against the wall, ensure the strap under top panel. 4.
Product Dimension 10
Limited Warranty The manufacturers products are warrantied against defects in material and workmanship while owned by the “Original Purchaser”. The term “Original Purchaser” is defined as the party or entity which purchases this manufacturerʼs furniture from an authorized retailer as shown by the original sales receipt. This warranty does not apply to “as is” or previously owned products.
