Installation Guide

ClearViewClearView

GLASS RAILINGS

ClearViewClearView

GLASS RAILINGS

ClearViewClearView

GLASS RAILINGS

Wood Deck Installation

We suggest using 3/8” diameter x 3.5” ASTM A307 Grade A structural bolts and ﬂat washer

. ASTM A307 Grade A

structural bolts and washer should be cadmium plated or stainless steel so they do not rust.

Lag bolts must be installed into rim joists or lam beam or properly blocked sub structure. If lag bolts are attached to

deck planks only failure will occur as a result of improper installation. Improper installation and failure may result in

injuries or death. Do it once and do it right!

INSTALLATION WITH

TWO OR THREE SPIGOTS

2 SPIGOT INSTALLATION

3 SPIGOT INSTALLATION

Will Withstand Hurricane Force Winds

Will Withstand Wind Gusts up to 115 MPH

Installation of Spigots Using Wood Planks

Installation of CVGR Spigots to wood planks are ﬁne as long as you use three

2” x10”s. You must tie the three plies of wood together with (4) #8 4” wood screws,

located 3” from spigot screws.

More installation information including additional fastener product recommendation

listed on next page. Product Speciﬁcations included as well.

PAGE 1
C G ClearView GLASS RAILINGS INSTALLATION WITH TWO OR THREE SPIGOTS 2 SPIGOT INSTALLATION Will Withstand Wind Gusts up to 115 MPH 3 SPIGOT INSTALLATION Will Withstand Hurricane Force Winds Wood Deck Installation We suggest using 3/8” diameter x 3.5” ASTM A307 Grade A structural bolts and flat washer. ASTM A307 Grade A structural bolts and washer should be cadmium plated or stainless steel so they do not rust. Lag bolts must be installed into rim joists or lam beam or properly blocked sub structure.
PAGE 2
Fastener Recommendation We recommend RSS Rugged Structural Screws by GRK Fasteners (product image shown). This product is available at Home Depot: • Internet #203525067 • Model #112225 • Store SKU #518167 Installation Tips • Mark spigot location on glass panels with a crayon or wax marker. This allows for fast and easier installation of panel in proper location.
PAGE 3
CLEARVIEW GLASS RAILINGS • 737 Quentin Avenue South • Lakeland, MN 55043 • ClearViewGlassRailings.com ACCORDANCE WITH 2015 IBC SECTION 2407 THAT REQUIRES ALL-GLASS 6. MECHANICAL FASTENERS, AS SHOWN. ENGINEER.FASTENERS, AS SHOWN. 7. MECHANICAL HEREIN. 6. THEDESIGNBED ABILITY OFAND THESHOWN EXISTING HOST STRUCTURE TO SAFELY SUPPORT THE LOADS 5. THE ABIILITY OF THE EXISTING HOST STRUCTURE TO SAFELY SHALL BE DETERMINED BY THE ENGINEER. SUPPORT THE LODS SHALL BE PROJECT DETERMINED BY THE PROJECT 5.