Product Manual

Instructions: Deluxe Class C RV Cover
WARNING:
Installation is best done with two
people. Never install on a windy
day or when the roof is slippery. Please
take care when you are on
a ladder or the roof.
CAUTION
Installation and removal is safer and
easier when done by two people. Please
consult your RV owners manual.
Tools Needed:
Scissors
Matches or lighter (optional)
Screwdriver (usually Phillips head)
for roof antennas
Installation
Note: Your cover has been packed so
that when unrolled on the roof it is in
the proper position for installation.
1. Cover or tape any sharp edges on
your RV that could wear against your RV
cover. Be sure to lower any
roof antennas.
2. Carefully climb up on the roof and
take your cover out of its storage bag.
Place the rolled-up cover at the front
center of the roof and unroll down the
center of the RV.
3
. Starting at the front, unfold your
cover from the center outwards.
Continue unfolding the cover as you
work toward the back, letting it fall over
the sides of your RV. Make sure the
corners of the cover are at the corners of
your RV.
4
. Climb down the rear ladder and
locate the ladder cap. (The cap helps
keep the top of the ladder from
stressing the cover). Fit it over the
ladder top and attach it to the rungs
with the hook and loop straps. Now
pull the back end of the cover down the
back of your RV.
5
. Your cover is equipped with triple
zippers on the front side panels. These
zippers allow the cover to fit RVs with
mirrors that do not fold against the RV.
Zip all three zippers down to the mirror
height, then zip the bottom zipper
to the bottom of the cover. Create an
opening at the mirror height by zipping
the top zipper up slightly and the center
zipper down slightly. Slip the opening
over the mirror and close the top and
bottom zippers around the mirror post.
Finish by zipping all the panels closed
on your cover then pull the elasticized
corners down over both bumpers
of
your RV.
6. Tie an end of one of the supplied
pre-cut ropes onto one of the D-rings
along the bottom hem. Put a small rock
in the provided toss bag, close the top
and tie the free end of the rope to the
bag D-ring. Now
toss the bag
and rope under
your RV to the
D-ring on the
opposite side.
Take the rope off the bag
and tie it to the D-ring.
Repeat with the remaining D-rings.
7
. Adjust the strap length on the white
tension panels across the front and
back to fit your RV. Don’t over tighten—
the straps should be snug, not drum
tight. To attach the straps into the side-
release buckles just insert the clip into
the buckle. To release the buckle press
the buttons on both sides and pull the
clip out of the buckle.
08cR55_1035079163 79263 79363 79463 79563 79663 79763
Use and Storage
The sides of your cover can be unzipped
for access to the front, entrance side
and rear. The panels can be rolled up
and held in place with the hook and
loop straps toward the top of each
panel.
A handy storage bag is provided. To
fit it in the bag fold your cover and roll
the cover tightly rather than stuffing it.
Never store a wet cover in the storage
bag or confined area as the cover can
be damaged by mildew.
Care
Spot clean with water, a mild soap and
a sponge. Don’t use abrasive cleaners
or brushes.
Three Year Limited Warranty
If this cover fails due to a defect in
workmanship and materials within three
years from the date of purchase Classic
Accessories will repair or replace it free
of charge.
Trailering or towing your RV with your
RV Cover on will invalidate the warranty.
This warranty gives you specific
rights and you may also have other
rights which vary from state to state.