Instructions / Assembly

Instructions: Lawn Mower Cover
WARNING!
Do not operate the lawn mower with the cover on.
CAUTION!
Let your lawn mower cool before you put the cover on.
CAUTION
If your lawn mower is new, use of this product is not recommended within the first four
weeks of ownership of the lawn mower. Some compounds used in new machines can
release gases that will cause the dyes in lawn mower covers to transfer to the machine,
potentially staining the lawn mower or its components. Lawn mower covers can be used
safely after this introductory period.
Fitting
Your Lawn Mower Cover fits most gas, electric and push reel mowers.
Installation
Check your lawn mower to make sure that there are no sharp objects or corners that could stress your
cover as you pull it on. Slip your cover over the top of your lawn mower, then pull the cover down on
all four corners. When you have the cover into place, connect the click-it buckle located behind the
handlebar.
If you are covering your lawn mower with the handle down or partially down you
can fold up any additional fabric and place it behind the click-it strap in the back.
You can leave rear-discharge grass catchers on or place them on top of your mower
(This cover will not fit over side discharge catchers).
Use and Storage
Your Lawn Mower Cover has an integrated storage bag. To fit your cover in the bag fold and roll it tightly
rather than stuffing it. Never store a wet cover in the storage bag or confined area as the cover can be
damaged by mildew.
Cleaning and Care
Clean your cover with a soft brush and luke-warm water. DO NOT USE SOAP as it may remove the
protective coatings added by the factory. Air dry.
do not iron
do not
pack wet
do not
use soap
line dry
no bleach
water
resistant
no tools
required
73117
11cH57_11719
CLASSIC ACCESSORIES, INC., KENT, WA USA 98032
©2011 classicaccessories.com