User's Manual

Undo Preparing a Drive for Removal
Before You Begin
You must log in with admin privileges to perform this task.
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters command mode for an installed
storage card.
Server /chassis # scope storageadapter slot
Step 2
Enters command mode for the specified
physical drive.
Server /chassis/storageadapter # scope
physical-drive drive-number
Step 3
Server /chassis/storageadapter/physical-drive #
undo-prepare-for-removal
Step 4
This example shows how to respin physical drive 3 after preparing the drive for removal.
Server# scope chassis
Server /chassis # scope storageadapter SLOT-3
Server /chassis/storageadapter # scope physical-drive 3
Server /chassis/storageadapter/physical-drive # undo-prepare-for-removal
Server /chassis/storageadapter/physical-drive #
Enabling Auto Learn Cycles for the Battery Backup Unit
Before You Begin
You must log in with admin privileges to perform this task.
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters command mode for an installed storage
card.
Server /chassis # scope storageadapter slot
Step 2
Enter the battery backup unit command mode.Server /chassis/storageadapter # scope bbu
Step 3
Enables the battery auto-learn cyclesServer /chassis/storageadapter #
enable-auto-learn
Step 4
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
124 OL-28893-01
Managing Network Adapters
Undo Preparing a Drive for Removal