User's Manual

Set as Boot Drive
Before You Begin
You must log in with admin privileges to perform this task.
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters command mode for an installed storage
card.
Server /chassis # scope storageadapter slot
Step 2
Enters command mode for the specified virtual
drive.
Server /chassis/storageadapter # scope
virtual-drive drive-number
Step 3
Specifies the controller to boot from this
virtual drive.
Server /chassis/storageadapter #
set-boot-drive
Step 4
This example shows how to specify the controller to boot from virtual drive 3:
Server# scope chassis
Server /chassis # scope storageadapter SLOT-3
Server /chassis/storageadapter # scope virtual-drive 3
Server /chassis/storageadapter/virtual-drive # set-boot-drive
Are you sure you want to set virtual drive 3 as the boot drive?
Enter 'yes' to confirm -> yes
Server /chassis/storageadapter/virtual-drive #
Modifying Attributes of a Virtual Drive
Before You Begin
You must log in with admin privileges to perform this task.
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters command mode for an installed
storage card.
Server /chassis # scope storageadapter slot
Step 2
Enters the command mode for the virtual
drive.
Server /chassis/storageadapter # scope
virtual-drive 3
Step 3
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
120 OL-28893-01
Managing Network Adapters
Set as Boot Drive