Network Router User Manual

14-53
Cisco 12000/10720 v3.2 Router Manager User Guide
OL-6690-01
Chapter 14 Routing
BGP Address Family Configuration
Neighbor Information
Neighbor IP Address—Specifies the IP address of the neighbor router for the
address family.
Remote AS—Specifies the neighbor routers autonomous system number. This
value can range from1 to 65535.
Activate—Enables the neighbor to exchange prefixes for the specified family type
with the local router.
Neighbor Send Community—Specifies the community attribute sent in the route
updates to a peer. The default is not to send community attribute in route updates.
Action
Add/Remove AF Neighbor—Clicking on the Add/Remove AF Neighbor button
opens the BGP Address Family - Neighbor Configuration window.
BGP Address Family—Neighbor Configuration
The BGP Address Family - Neighbor Configuration window allows the user to
add or remove neighbor configurations for BGP address families. To configure a
Neighbor for an address family, proceed as follows:
Step 1 Open the BGP Address-Family Configuration window. See “Viewing the
AF-General Tab on the BGP Address-Family Configuration Window” section on
page 14-38 for further details. Click on the AF—Neighbor Tab.
Step 2 Choose a chassis and the address family from the left side of the window.
Note You can choose multiple chassis and address families (from the list
provided at the left side of the window) which allows you to launch the
BGP Address Family - Neighbor Configuration window for the selected
chassis.
Step 3 Click on the Add/Remove AF Neighbor button to open the BGP Address Family
- Neighbor Configuration window.