User's Manual

For deployment engineers, download the runtime program “8000Deploy3G.shx” to the

mobile computer, and then use it to deploy a set of standard settings to the cradle, as

well as perform functionality testing.

1) Run one of the CipherLab download utilities on your desktop computer, for example,

“ProgLoad.exe”. Choose the correct interface, COM port, baud rate, file type, and

browse the file system to locate the utility “8000Deploy3G.shx”.

2) Press [8]+[Power] on the mobile computer to turn it on and access the Program

Manager menu.

You may download the program directly to the active memory sector “ACT”, or to an

empty sector and activate the program later. Choose the correct interface and baud

rate that match the settings on your desktop computer.

3) Upon completion of the download process, you have to activate the program if it is

downloaded to an empty sector.

4) The program “8000Deploy3G.shx” will start itself in a few seconds.

5) Set Baud rate, if necessary (please refer to 3.1 Detect Baud Rate).

6) Go to 2. Settings | 2. Configure to configure cradle settings, such as PIN code,

name of access point, etc.

Note: You must input the correct PIN code even though authentication is disabled!

You can check all these settings via 2. Settings | 1. Information.

hapter

USING 8000 TO CONFIGURE 3G/GPRS CRADLE