Use Instructions

type/device pairing connection is successful, the blue light flashes once continuously for
about 5 seconds, and enters the standby working state.
Note: If the paired device is not connected for 5 minutes, the headset will automatically
shut down
2) Answering a call: After the earphone hears the prompt tone from the mobile device,
press the function button once to answer the call, or press the answer button on the phone to
answer the call.
3) Outgoing call: In the standby mode, quickly press the power button twice to broadcast
the last call.
In the standby working state, press the outgoing call mode of the mobile phone and enter the
number to make a call
4) Ending the call: To end the call, press the power button the headset will emit a prompt
tone.
If during a call, the other party hangs up the headset will emit a beep to automatically end
the call.
5) Volume increase/decrease: Short press the +/- button during music/calls to increase
and decrease the volume, long press to continuously increase and decrease the volume to the
maximum volume, the headset emits a "maximum volume" prompt.
4. Shutting down
Press and hold the power button for about 4 seconds, the red light flashes twice quickly and
the headset emits a beep and will soon turns off.
When the earphone is far away from the receiving range, it will automatically shut down
after about 5 minutes of inactivity.
5. Low battery
When working, your device will prompt you that the battery is low. Charge the headset as
soon as possible for uninterrupted use.
Common Problems and Troubleshooting
1. When the red indicator light flashes continuously and quickly, the headset emits a rapid
tone indicating that the battery of the Bluetooth headset is low, please charge the headset as
soon as possible.
2. The device cannot be turned on. For safety reasons, the basic power of the device will be
controlled at about 20~50% when it leaves the factory. Perhaps the power of the new device
will be exhausted. If you cannot turn on, please charge the headset first and then turn it on.