User guide

KFA SERIES Installation Instructions
8
Figure 3
Figure 4
Figure 5
Attach Centris Head to Recessed Mount Display
CAUTION: If display uses a screw size other than
those included in the kit, DO NOT use the screws
provided. Using the wrong screws could result in
damage to your monitor.
1. Uninstall end lock using the 5/32" hex key (H). (See
Figure 6)
2. Remove Centris head from mounting rail.
(See Figure 7)
Figure 6
Figure 7
3. Place display face down on a clean dry surface.
4. Place four 3/4" or 3/8" nylon spacers (E or F) over four
mounting holes in display back.
NOTE: Refer to Table 1 to select the applicable screw
and spacer combination.
5. Align Centris head mounting holes with four nylon
spacers.
6. Secure Centris head to display using four
M4 x 20mm Phillips pan head screws (G), or four M4
x 30mm Phillips pan head screws (D).(See Figure 8)
Display
(C) x 2
1
2
Display
Centris Head
Array Rail
Display
Centris Head
Array Rail
(C) x 2
3
Square Nut
End Lock
Centris Head
Array Rail
1
Centris Head
Array Rail
2