Instructions / Assembly

Mount the brackets and screw the track onto the ceiling.
4
Adjust the panel track to the width needed. Be careful not to over extend the track and cause it to separate completely.
Adjustable
R
Ceiling Mount
Double Rail Sliding Panel System
INSTRUCTION
Check all pieces to make sure you have received complete set
Snap the guide rails into the slider clips (8 slider clips are already installed in track)
*Make sure the Velcro side on head-rail is facing you, and follow the correct number sequence.
Guide Rail - 1
x 2
Guide Raikl - 2
x 2
L Bracket
x 3
Wall Anchor
x 3
Screw - 1
x 3
Screw - 1
Screw - 1
Screw - 2
x 1
Screw - 3
x 2
2
1
2
1
2
1
2
1
2
1
2
2
1
1
1
1
1
1
1
1
2
2
1
5
6
2
3
Bottom Rail
Inner Alu Bar
Screw - 1
Guide Rail - 1
x 2
Slider Clips
come pre-installed to track.
Guide Rail - 2
x 2
x 4
x 4
Screw - 4
x 12
x 4
Adjustable Sliding Track x 1
Adjustable Sliding Track x 1
3.4.1.2
Measure the length needed for the panels.
If needed, you may adjust the length of
your panels to t your desired length.
Cut the panel /panels according to your
measurements.
Then take your metal strip and place at
fresh cut for that clean look.
5
Attach the panel pieces to the guide rails.
6
Measure the length you need.
Measure the length you need.
Cut the panel according to your measurements.
Cut the panel according to your measurements.
Inner Alu Bar
Bottom Rail
Panel
Measure the 3 positions and
screw to the wall.
Wall Mount
Note :
Not to screw to the end,
it need about 1/8 in. gap
to hold the bracket.
Screw - 1Screw - 1Screw - 1
1/8 in.
Screw - 3
Screw - 2
Screw - 3
Screw the track to the L Bracket.
Install the track to the wall.
It may need 2 people to nish.