Service manual

14. Tire Check
14.1. Pattern depth check
The related regulations specify the depth of the tire surface. When the remaining depth of tire
pattern reaches the limit of 1.6 mm or the tire pattern is worn to the tip of triangular mark as shown
in the figure above, a wear strip will appear on the tire tread, which indicates the performance and
safety of tire here considerably reduce and the tire must be replaced.
14.2. Tire pressure check
Tire Pressure:
Item
Tire
Pressure
(kPa)
Spare
Tire
Unloaded/S
emi-loaded
230
Front
Wheel
Laden
230
Unloaded/S
emi-loaded
210
Rear
Wheel
Laden
210
230
Precautions on tire pressure
The pressure values listed in the table above are applicable to the tire in cold state. The aire
pressure will slightly increase if the tire is heated, but it is unnecessary to reduce the air pressure;
and the pressure values listed in the table above shall increase by 20Kpa if the winter tire is
available.
In order to facilitate your search of specified charging pressure value, there is a self-adhesive label
attached to the inner side of the filler cap, on which is printed with the specified value of tire
charging pressure.
15. Timing Belt Check
Check its wear and tension of the timing belt, and regulate or replace it if necessary. The tension
requirement after the timing belt is regulated: In the intermediate position of two wheels at the
Wear Limit