User Manual
TABLE OF CONTENTS 1. Before You Begin .......................................................................................................... 3 What Is Included ............................................................................................................................. 3 Unpacking Instructions .................................................................................................................... 3 Claims........................................................................
1. BEFORE YOU BEGIN What Is Included • • • • • COLORrail™ IRC IP Power Cord DMX In Adapter DMX Out Adapter • • 2 Hanging Brackets with Mounting Hardware (L-brackets) Warranty Card Quick Reference Guide Unpacking Instructions Immediately upon receipt, carefully unpack the product and check the box to make sure you have received all the parts indicated above in good condition.
Product at a Glance Use on Dimmer Outdoor Use Sound-Activated DMX Master/Slave Safety Notes x P x P P Auto Programs Auto-ranging Power Supply Replaceable Fuse User-Serviceable P P x x Please read the following Safety Notes carefully before working with the product. The Notes include important safety information about installation, usage, and maintenance. • • • • • • • • • • • • • • • • Always connect the product to a GFI (ground fault interrupter) circuit to avoid the risk of electrocution.
2. INTRODUCTION Power In Product Overview DMX In DMX Out Power Out LED Display Product Dimensions COLORrail™ IRC IP User Manual Rev.
3. SETUP AC Power The COLORrail™ IRC IP has an auto-ranging power supply and it can work with an input voltage range of 100–240 VAC, 50/60 Hz. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
4. OPERATION Control Panel Operation To access the control panel functions, use the three buttons located underneath the display. Note: The
Configuration (Standalone) Set the product in one of the standalone modes to control it without a DMX controller. • Connect the product to a suitable power outlet. Never connect a product that is operating in any standalone mode to a DMX string connected to a DMX controller. Products in standalone mode may transmit DMX signals that could interfere with the DMX signals from the controller. There is no button. After the COLORrail™ IRC IP is configured the display will show the last item configured.
Master/Slave Mode The Master/Slave mode allows a single COLORrail™ IRC IP unit (the master) to control the actions of one or more COLORrail™ IRC IP units (the slaves) without the need of a DMX controller. The master unit will be set to operate in any standalone mode, while the slave units will be set to operate in Slave mode. Once set and connected, the slave units will operate in unison with the master unit. To enable Master/Salve mode, do the following: Slave units: 1.
Infrared Control The COLORrail™ IRC IP is fully compatible with the IRC-6 infrared remote control from CHAUVET® (sold separately). To enable the infrared functionality with the COLORrail™ IRC IP, follow the instructions below: • Press
Configuration (DMX) DMX Personalities and Starting Address Set the product in DMX mode to control with a DMX controller. 1. Connect the product to a suitable power outlet. 2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket on the product. The COLORrail™ IRC IP has has a total of six DMX personalities, ranging from a 2-channel mode for basic control to a 26-channel mode with more advanced control over the lights.
4-c 7-c 14c Page 12 of 17 Channel Function Value Setting 1 2 Master Dimmer Red 000 ó 255 0–100% 000 ó 255 0–100% 3 4 Green Blue 000 ó 255 0–100% 000 ó 255 0–100% Channel Function Value Setting 1 Master Dimmer 000 ó 255 0–100% 2 Red 000 ó 255 0–100% 3 4 Green Blue 5 Color Macros 000 ó 255 000 ó 255 000 ó 008 009 ó 017 018 ó 026 027 ó 035 036 ó 044 045 ó 053 054 ó 062 063 ó 071 072 ó 255 6 Auto Program Speed 7 Strobe Channel Function 0–100% 0–100% No function Red Yellow Gree
26c Channel Function Value Setting 1 Master Dimmer 000 ó 255 0–100% 2 3 4 Red Green Blue 000 ó 255 0–100% 000 ó 255 0–100% 000 ó 255 0–100% Section 1 5 6 7 Red Green Blue 000 ó 255 0–100% 000 ó 255 0–100% 000 ó 255 0–100% Section 2 8 9 10 Red Green Blue 000 ó 255 0–100% 000 ó 255 0–100% 000 ó 255 0–100% Section 3 11 12 13 Red Green Blue 000 ó 255 0–100% 000 ó 255 0–100% 000 ó 255 0–100% Section 4 14 15 16 Red Green Blue 000 ó 255 0–100% 000 ó 255 0–100% 000 ó 255 0–100% Section 5
5. TECHNICAL INFORMATION Product Maintenance Dust build-up reduces light output performance and can cause overheating. This can lead to reduction of the light source’s life. To maintain optimum performance and minimize wear, you should clean your lighting products at least twice a month. However, be aware that usage and environmental conditions could be contributing factors to increase the cleaning frequency. To clean the product, follow the instructions below: 1. Unplug the product from power. 2.
6. TECHNICAL SPECIFICATIONS Dimensions and Weight Length Width Height Weight 43.6 in (1,109 mm) 4.7 in (120 mm) 5.1 in (130 mm) 12.4 lb (5.6 kg) Note: Dimensions in inches rounded to the nearest decimal digit. Power Power Supply Type Range Voltage Selection Switching (internal) 100–240 VAC, 50/60 Hz Auto-ranging Parameter 120 V, 60 Hz 230 V, 50 Hz Consumption 60 W 65 W Operating 0.5 A 0.
RETURNS To return a product or request support: • In the U.S., contact CHAUVET® World Headquarters (see Contact Us). • In the UK or Ireland, contact CHAUVET® Europe Ltd. (see Contact Us). • In Mexico, contact CHAUVET® Mexico (see Contact Us). • In any other country, DO NOT contact CHAUVET®. Contact your distributor. See www.chauvetlighting.com for distributors outside the U.S., United Kingdom, Ireland, or Mexico. If you live outside the U.S.
CONTACT US WORLD HEADQUARTERS - CHAUVET® General Information Technical Support Address:5200 NW 108th Avenue Voice: (954) 577-4455 (Press 4) Sunrise, FL 33351 Fax: (954) 756-8015 Voice: (954) 577-4455 Email: tech@chauvetlighting.com Fax: (954) 929-5560 World Wide Web Toll free: (800) 762-1084 www.chauvetlighting.com UNITED KINGDOM AND IRELAND - CHAUVET® Europe Ltd. General Information Technical Support Address:Unit 1C Email: Brookhill Road Industrial uktech@chauvetlighting.