Installation & Assembly

Put Chair Back (A) on smooth flat surface. Attach Seat With Cushion (B) to the Chair

Back (A) use Long Bolt (D), Short Bolt (F), Lock Washer (G) and Flat Washer (H) on five

holes of the Chair Back (A). Turn the Allen Key (I) in the Long Bolt (D) and Short Bolt (F).

But not too tight.

Take the Allen Key, and turn the bolts

until the legs are secure.

DO NOT TIGHTEN COMPLETELY.

Stop when you feel you are adding

force to tighten the bolt.

Attach Front Leg (C) to the Seat With Cushion (B) use Medium Bolt (E), Lock Washer (G)

and Flat Washer (H) on both holes of the Seat With Cushion (B). Turn the Allen Key (I) in

the Medium Bolt (E). But not too tight.

Stand chair up on an even surface

and check that it is balanced. If

there is a slight wobble, apply

downward pressure in the corner

where a leg is uneven. Keeping

pressure in that corner, tighten all

bolts. If balanced, apply downward

pressure evenly in the center and

tighten all bolts. Do not over-tighten

beyond hole depth.

Cleaning & Care:

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean

surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen

over time. Periodically check that all connections are tight.

Helpful Tip:

-Instead of applying downward pressure while

reaching under to tighten bolts, have someone

sit in the chair while you tighten the bolts.