Instruction Manual

4
6. Place part (E) on top of part (F) and tighten with the provided screws
using a wrench.
7. Screw part (D) to part (E), part (C) to part (D) and part (B) to part (C).
Please note that due to the quality of materials used, it is highly recommended
to secure the base into a solid surface such as concrete or wooden patio (bolts
included).
(C).
3. Screw bracket (J) into part (H) using the provided screws as shown in
Replacing the Batteries
(After several years of use, the batteries may need replacing).
1. Remove the top (A) from the fixture (B)
by releasing the 2 screws (Fig. 3).
2. Make sure the ON/OFF switch is in the “OFF” position.
3. Release the 3 screws on the silver reflector and remove
the old batteries (Fig. 4). Make sure the new batteries are
high quality –1 x Li-ion Battery Pack
(3.2 Volt / 3,000 mAh).
4. Install the new batteries into the battery compartment.
5. Reassemble the unit by reversing the above procedure.
Fig. 2
Fig. 4
Fig. 3
1. Repeat steps 1 to 6.
2. Screw part (D) to part (E). Part (C) to part (D) and part (H) into part
Fig. 2.
4. Repeat step 3, two times and three times
5. Screw part (K) on top of part (H) or (I).