Installation & Assembly

5.
SUPPLY CIRCUIT
Ground
Conductor
Outlet Box
Green
Ground
Lead
Ground to
Downrod
BLACK
WHITEWHITE
BLACK
BLUE
GREEN
WHITE
BLUE
BLACK WHITE
Diagram indicates optional light kit wiring.
WARNING
ELECTRICAL DIAGRAMS ARE FOR REFERENCE
ONLY. OPTIONAL USE OF ANY LIGHT KIT
SHALL BE UL LISTED AND MARKED SUITABLE
FOR USE WITH THIS FAN.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK. DO NOT USE THIS FAN WITH ANY
SOLID-STATE SPEED CONTROL DEVICE.
Make the Electric
Connections
REMEMBER to disconnect the power.
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan to your
household wiring. Use the wire connecting nuts
supplied with your fan. Secure the connectors with
electrical tape. Make sure there are no loose strands or
connections.
Step 1. Connect the ground conductor of the 120V
supply (this may be a bare wire or a wire with
green colored insulation) to the green ground
lead(s) of the fan. (Figure 8)
Step 2. Connect the fan motor white wire to the
supply white (neutral) wire using a wire nut.
(Figure 8)
Step 3. Connect the fan motor black wire to the
supply black (hot) wire using a wire nut. (Figure 8)
Step 4. Connect the blue wire for light kit to the
black household supply wire.
WARNING
CHECK TO SEE THAT ALL CONNECTIONS
ARE TIGHT, INCLUDING GROUND, AND THAT
NO BARE WIRE IS VISIBLE AT THE WIRE
NUTS. EXCEPT FOR THE GROUND WIRE.
Step 5. Turn wire nut connections upward, spreading
them apart so the green (ground) will be on one side
of the outlet box and the white, black and blue wire
will be on the other side, and push carefully up into
the outlet box.
Figure 8