Manual

OPERATING INSTRUCTION

WARNING: ALWAYS KEEP THE PISTOL POINTED IN A SAFE DIRECTION WHEN LOADING

AND UNLOADING. INSPECT THE CHAMBER AND BORE OF THE BARREL

FOR ANY OBSTRUCTION, EXCESSIVE OIL OR GREASE. FAILURE TO DO

SO MAY RESULT IN GUN DAMAGE AND/ OR INJURY TO THE SHOOTER OR

THOSE NEARBY.

To load the magazine, place the first cartridge in the front end of the magazine

follower and push it down until it can be slid in under the feed lips of the magazine.

Place the second cartridge on the top of the first and force it down in the same way as

the first one. Repeat this procedure until the magazine contains the number of

cartridges you intend to load. The magazine can take as many as eight (8) rounds.

To load the pistol, insert the loaded magazine into the grip (handle} and push it up until

the magazine release engages in its slot locking in place. Hold the pistol firmly with

your firing hand. Grasp the slide at its serrated section with your other hand and pull

it to the rear as far as it will go. (Note: the hammer can be cocked first to make the

slide easier to pull). Then, release the slide smartly. A cartridge is now loaded in the

chamber and the pistol is ready to fire. Push the safety lock upwards into the "SAFE"

position and leave it there until ready to shoot.

FIRING

To fire the pistol, press the safety lock down to the "FIRE" position. Obtain the correct

sight alignment and sight picture and squeeze the trigger. To fire successive shots, the

trigger must be released and squeezed repeatedly. When the last cartridge from the

magazine has been fired, the slide remains to the rear. If you intend not to shoot or

cease firing, remember you have a loaded gun in your hand. First keep the gun

pointed in a safe direction and keep your finger off the trigger. Then, unload the gun

by following the unloading procedure below.

UNLOADING

To unload, press the magazine release and remove the magazine. If the slide is in the

forward position, pull it to the rear and retain by pushing the slide stop up. Inspect

the chamber to make sure that the pistol is clear and unloaded. If the chamber is

empty, press the slide stop down while squeezing the trigger, allowing the slide to

go forward. If there is a shell or unfired cartridge in the chamber, manually remove