Installation manual

B-4
ChargePoint® Charging Stations
Power Select - Overview of Steps
1. Configure Power Select
2. Apply the Electrical Rating label
Power Select - Step by Step Instructions
Step 1: Configure Power Select
Power up the station. If the station displays the Installation Wizard, follow the onscreen instructions to enable
Power Select. If the station does not display the Installation Wizard, configure Power Select using the Service
Menu as described below.
Display the station’s Service Menu:
• if the station is not activated on ChargePoint, simultaneously press and hold
the two leftmost buttons and the rightmost button for two seconds.
• if the station is activated on ChargePoint, scan your ChargePoint Service card.
Scroll down to select Circuit Breaker Configuration.
Choose the breaker size that matches what is installed for the station.
Select Exit to leave the Service Menu.
NOTE: If you make an error when using the Installation Wizard, your ChargePoint
Network Manager can change the station’s settings by logging into ChargePoint,
selecting the station from the Manage Stations page, selecting the Configuration
tab, and then clicking Edit to modify the station’s Power Sharing and Power Select
settings.
If the station must be reconfigured using the Installation Wizard, contact
ChargePoint Customer Support at 1-877-850-4562 to have the station reset to its
factory default configuration.
Step 2: Apply the Electrical Rating label
See next page.
If the Installation Wizard does not
display upon power up, simultane-
ously press and hold these three
buttons for two seconds to display
the Service Menu on an unactivated
station
Press the button
immediately
below the menu
item to choose
the associated
function