Installation manual

3-5
Installing a Wall Mount
Step 4: Prepare Retractor for Mounting
To prepare the retractor for mounting:
• Position the retractor packaging so that the bottom of the retractor is near the bottom of the wall.
IMPORTANT: Do not unwrap the ropes.
• Remove and discard the two 3/8” (10 mm) drive shipping screws from the front face of the retractor.
NOTE: When you remove the shipping screws, the retractor’s counterweights are free to move in either direction.
Therefore, do not tilt or carry the retractor assembly with the top end lower than the bottom end.
• Remove the foam packaging from the retractor.
• OPTIONAL: If necessary, remove or replace the EV PARKING sign. See Appendix C.
Discard
shipping
screws
Top
Bottom
When handling, always
keep the top end higher
than the bottom end.