Installation manual

3-1

Installing a Wall Mount

Before You Start

You need the following:

• Drill and Tap for appropriate wall attachment hardware

• Attachment hardware, such as 3/8” x 3” (M10 x 75 mm) lag bolts (coach screws) if mounting to a wood wall

• Ratchet and 9/16” (15 mm) deep socket

• #2 Phillips screwdriver

• Tape measure

• Bubble level

• Marker

• Wire stripper

• Voltage tester

Overview of Steps

Installing the wall mount involves a few simple steps, summarized below and detailed in the remainder of this chapter:

1. Check Boxes for Correct Contents (page 3-2)

2. Drill Holes in Wall (page 3-3)

3. Mount Rear Brackets to Wall (page 3-4)

4. Prepare Retractor for Mounting (page 3-5)

5. Mount Retractor (page 3-6)

6. Install Conduit (page 3-7)

7. Install Main Body (page 3-8)

8. Connect Wiring (page 3-9)

9. Check Voltages (page 3-10)

When you have completed these steps, you will be ready to install the head and top cap as described in Chapter 4.