Installation manual

2-7
Installing a Bollard Mount
Step 6: Install Retractor
To install the retractor:
• Insert the black cap into the space at the top of the
main body, between the main body and the retractor,
as shown.
• With a Phillips screwdriver and at least one of the
four ¼” - 20 x 1 ¼” screws in hand, position the
retractor against the back of the main body. Place
the slot at the bottom of the retractor over the knob
at the bottom of the main body, as shown.
IMPORTANT: Hold the retractor in place until
you’ve secured it with at least one screw.
• From inside the main body, insert the four ¼” - 20 x
1 ¼” screws through the main body and the retractor,
and tighten to 60 in-lbs (7 Nm).