Installation manual

4-6

ChargePoint® Charging Stations

TO INSTALL A SCREW TYPE TOP CAP (to install a snap type top cap, see the previous page)

a) Place the top cap over the head assembly as shown, ensuring correct alignment.

b) Using a Phillips screwdriver, secure the top cap to the head assembly by inserting the two supplied screws into the

back of the top cap and tightening to 20 in-lbs (2.3 Nm).

Ensure correct alignment

so the top cap slides into

its secured position:

The small hole in each

of the two protruding

tabs on the bottom of

the top assembly must

slide and then snap

over the corresponding

nodule on the side of

the head assembly.

Tab

Nodule