Operators Manual

100326-1 - 25 TON FULL BEAM LOG SPLITTER
ASSEMBLY
18
Towing Log Splitter Safety
1. Always check local and state regulations regarding the
requirements for towing, licensing and lights.
2. Before towing make sure the log splitter is correctly and
securely attached to the vehicle and the safety chains
attached with enough slack to allow for turning.
3. Support leg must be pinned in the “UP” position for towing.
4. Never exceed the max. travel speed of 45 mph (72 km/h).
Towing the log splitter at speeds greater than 45 mph
(72 km/h) could result in serious injury or death. Always
adjust your towing speed according to the terrain and
conditions.
5. Always disconnect the log splitter from the towing vehicle
before operating.
Log Splitter Location
This log splitter must have at least seven feet of clearance from
combustible material. Leave at least three feet of clearance
on all sides of the log splitter to allow for adequate cooling,
maintenance and servicing. DO NOT place the log splitter near
vents or intakes where engine exhaust fumes could be drawn
into occupied or confined spaces. ONLY operate the log
splitter outdoors.
The log splitter needs to be on a dry level surface with good
footing. DO NOT work on mud, ice, tall grass, brush or snow.
Only operate log splitter from work zone shown below.
W
o
r
k
Z
o
n
e
HORIZONTAL OPERATING
POSITION
W
o
r
k
Z
o
n
e
VERTICAL OPERATING
POSITION

NOTICE
For Vertical Operation:
– Remove the beam lock-pin from the beam bracket
– Use handle on cylinder to rotate beam to vertical
position.
– Insert beam lock-pin in the pivot bracket.