Installation Guide

Installation

STEP 14 Wire the Safety Reversing Sensors

If your garage already has wires installed for the safetyreversing sensors, proceed to page 25.

HARDWARE

Ins

ulated Staple

(Not Shown)

OPTION A INSTALLATION WITHOUT PRE-WIRING

1. Run the wire from both sensorsto the garage door opener.Attach the wire to the wall and ceiling

with the staples.

2. Strip 7/16 inch (11 mm) of insulation from each setofwires.Separate the wires.Twistthe white

wires together. Twistthe white/black wires together.

3. Insertthe white wires into the white terminal on the garage door opener.Insertthe white/black

wires into the grey terminal on the garage door opener.To insert or remove the wires from the

terminal, push in the tab with a screwdriver tip.

Staple

7/16" (11 mm)

WHITE

GREY

RED