Manualshelf

Installation Instructions

ManualsBrandsChamberlain ManualsDoors1/2 HP Belt Drive Garage Door Opener (Good)
11121314151617181920
16
Installation
STEP 6 Install the light bulbs
To preventpossible OVERHEATING ofthe end panel or light socket:
l Use ONLY A19 incandescent (100W maximum) or compact fluorescent (26W maximum) light
bulbs.
l DO NOT use incandescent bulbs larger than 100W.
l DO NOT use compact fluorescent lightbulbslarger than 26W (100Wequivalent).
l DO NOT use halogen bulbs.
l DO NOT use short neck or specialtylightbulbs.
1. Pull on the top sides ofthe lightlens and rotate the light lensdown.
2. Insertan A19 incandescent(100W maximum) or compact fluorescent(26W, 100W
equivalent) lightbulb into the light socket.
3. Rotate the lens up to close.
NOTE: Do not use halogen, short neck, or specialty light bulbs as these may overheat the end panel or
light socket. Do notuse LED bulbs as they may reduce the range or performance of your remote
controls.
or
or
STEP 7 Attach the emergency release rope and handle
To preventpossible SERIOUS INJURY or DEATH from a falling garage door:
l If possible, use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could result in an open door falling
rapidly and/or unexpectedly.
l NEVER use emergency release handle unless garage doorwayis clear of persons and
obstructions.
l NEVER use handle to pull door open or closed.If rope knotbecomes untied, you could fall.
1. Insertone end of the emergency release rope through the handle. Make sure that“NOTICE”
is right side up. Secure with an overhand knot atleast 1" (2.5 cm) from the end of the rope to
prevent slipping.
2. Insertthe other end of the emergency release rope through the hole in the trolley release arm.
Mount the emergency release within reach, butatleast 6 feet (1.83 m) above floor, avoiding
contactwith vehiclesto prevent accidental release and secure with a knot.
NOTE: If it is necessary to cut the emergency release rope, seal the cut end with a match or lighter to
prevent unraveling.Ensure the emergency release rope and handle are above the top of all vehicles to
avoid entanglement.