Instructions / Assembly
Table Of Contents
- ENGLISH
- BILT Intelligent Instructions
- Installation Manual
- Contents
- Safety Symbol and Signal Word Review
- Unattended Operation
- Preparation
- Assembly
- Installation
- STEP 1 Determine the Header Bracket Location
- STEP 2 Install the Header Bracket
- STEP 3 Attach the Rail to the Header Bracket
- STEP 4 Position the Garage Door Opener
- STEP 5 Hang the Garage Door Opener
- STEP 6 Install the Light Bulbs
- STEP 7 Attach the Emergency Release Rope and Handle
- STEP 8 Install the Door Bracket
- STEP 9 Connect the Door Arm to the Trolley
- STEP 10 Install the Door Control
- STEP 11 Wire the Door Control to the Garage Door Opener
- STEP 12 Attach the Warning Labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect Power
- STEP 16 Align the Safety Reversing Sensors
- Adjustments
- Battery Backup
- myQ® App Control
- Operation
- Maintenance
- Troubleshooting
- Warranty
- Automatic Garage Door Opener Safety & Maintenance Guide
- Repair Parts
- SPANISH
31
To prevent possible SERIOUS INJURY or DEATH from electrocution or re:
l Be sure power is NOT connected to the opener, and disconnect power to circuit BEFORE removing cover
to establish permanent wiring connection.
l Garage door installation and wiring MUST be in compliance with ALL local electrical and building
codes.
l NEVER use an extension cord, 2-wire adapter, or change plug in ANY way to make it t outlet. Besure the
opener is grounded.
Toavoidinstallationdiculties,donotruntheopeneratthistime.
To reduce the risk of electric shock, your garage door opener has a grounding type plug with a third grounding
pin. This plug will only t into a grounding type outlet. If the plug doesn’t t into the outlet you have, contact
aqualied electrician to install the proper outlet.
White Wire
Black Wire
Installation
STEP 15 Connect Power
THEREARETWOOPTIONSFORCONNECTINGPOWER:
OPTIONA- TYPICALWIRING
1. Plug in the garage door opener into a grounded outlet.
2. DO NOT run garage door opener at this time.
OPTION B- PERMANENTWIRING
Ifpermanentwiringisrequiredbyyourlocalcode,refertothefollowingprocedure.Tomakeapermanent
connectionthroughthe7/8-inchholeinthetopofthemotorunit(accordingtolocalcode):
1. Remove the motor unit cover screws and set the cover aside.
2. Remove the attached 3-prong cord.
3. Connect the black (line) wire to the screw on the brass terminal; the white (neutral) wire to the screw on the
silver terminal; and the ground wire to the green ground screw. The opener must be grounded.
4. Re install the cover.
Ground Tab
Green Ground Screw
Ground Wire