User's Manual
Table Of Contents
- Owner's Manual
- CONTENTS
- Preparation
- Assembly
- Installation
- STEP 1 Determine the header bracket location
- STEP 2 Install the header bracket
- STEP 3 Attach the rail to the header bracket
- STEP 4 Position the garage door opener
- STEP 5 Hang the garage door opener
- STEP 6 Install the light bulbs
- STEP 7 Attach the emergency release rope and handle
- STEP 8 Install the door bracket
- STEP 9 Connect the door arm to the trolley
- STEP 10 Install the door control
- STEP 11 Wire the door control to the garage door opener
- STEP 12 Attach the warning labels
- STEP 13 Install the Protector System®
- STEP 14 Wire the Safety Reversing Sensors
- STEP 15 Connect power
- STEP 16 Ensure the safety reversing sensors are aligned
- STEP 17 Ensure the door control is wired correctly
- Adjustments
- Operation
- Maintenance
- Troubleshooting
- Accessories
- Warranty
- Contact Information
- Repair Parts
- Spanish
37
Maintenance
Maintenance Schedule
EVERY MONTH
• Manuallyoperate door. If it is unbalanced or binding,call a trained door systemstechnician.
• Check to be sure door opens and closes fully. Adjustifnecessary,see page 28.
• Testthe safety reversal system. Adjust ifnecessary, see page 28.
EVERY YEAR
• Oil door rollers,bearings and hinges.The garage door opener does not require additional
lubrication. Do not grease the door tracks.
The Remote Control Battery
To preventpossible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce riskoffire, explosion or chemical burn:
• Replace ONLY with 3V2032 coin batteries.
• DO NOT recharge,disassemble, heat above 212°F (100°C) or incinerate.
The 3V2032 lithium batteryshould produce power for up to 5 years. If
the battery is low,the remote control’s LED will not flash when the
button is pressed.
To replace battery, pryopen the case firstin the middle (1),then at
each side (2 and 3) with the visor clip.
Replace the batteries with only 3V2032 coin cell batteries.Insert
batterypositive side up. Dispose of old batteries properly.
1
2
3
NOTICE:To complywith FCC and/orIndustryCanada (IC)rules,adjustmentormodificationsofthistransceiverare prohibited. THERE
ARENOUSER SERVICEABLEPARTS. Any changesormodifications not expresslyapproved by the partyresponsible forcompliance
could void the user'sauthorityto operate the equipment.
Thisdevice complieswith Part 15 of the FCC rules and IC RSS-210.Operation is subjectto the following two conditions: (1)thisdevice
maynotcause harmfulinterference, and (2)thisdevice must acceptanyinterference received, including interferencethat maycause
undesired operation.
ThisClassBdigitalapparatuscomplieswith Canadian ICES-003.
AVIS: Lesrèglesde la FCC et/ou d’Industrie Canada (IC)interdisenttoutajustement ou toute modification de ce récepteur.IL
N’EXISTEAUCUNEPIÈCESUSCEPTIBLED’ÊTREENTRETENUEPAR L’UTILISATEUR. Toutchangementou toute modification non
expressément approuvé parlapartieresponsablede la conformité peut avoirpourrésultat d'annulerl'autorité de l'utilisateurde faire
fonctionnerl'équipement.
Cet appareilestconforme auxdispositionsde la partie 15 du règlementde laFCCet de l'norme ICRSS-210. Son utilisation est
assujettie auxdeuxconditoinssuivantes:(1)ce dispositif ne peutcauserdesinterférencesnuisibles,et (2)ce dispositifdoit accepter
toute interférence recue, ycomprisune interférence pouvantcauserun fonctionnementnon souhaité.
Cet appareilnumerique de la classe Best conforme a la norme NMB-003 du Canada.